|
Laydown Applications
|
| WTF has many
concrete form designs that allow the concrete form to
be laid on its side. The 36x48 laydown has additional
bracing to allow for this use. For customers with concrete
forms that are not designed to be laid on their side
WTF has perfected hardware for this application. We
recommend the following guidelines. |
|
|
| |
|
Flat
Steel U-Tie |
|   For
laydown applications ONLY! Not to be used in close trench
conditions where stripping requires pulling top of form
down toward ground. No pins or wedges required.
-Maximum wall height: 36"
-Maximum tie spacing: 24"
-Up to 36" ~ Specify Nominal or Full
|
| |
|
Wire
Base Tie |
|   Wire
base ties are used in laydown form applications. Drive
wedges through raised loops to secure base tie through
rail.
-Maximum wall height: 36"
-Maximum tie spacing: 24"
-Up to 20" ~ Specify Nominal or Full |
| |
|
Base
Tie Pin (Silver Bullet)
|
|   For
laydown applications ONLY! Base tie pins hold tie in
place at the base of the concrete form.
-Maximum wall height: 36"
-Maximum tie spacing: 24"
Product #API10000000000
|
| |
|
Flathead
Pin
|
|   The
flathead pin is used in laydown applications with standard
ties. Can also be used when pouring a concrete wall
against an existing structure. This pin is the only
design used in laydown applications in walls over 36"
tall.
Product #SPI20000000000 |
| |
|
|
|
